Remember or make a label what is or whre your high/low should be connected and dont touch or remove anything else but first put some.tape on the other side of the terminal where the old wiring. W ready your paper and pencil/ballpen to make your label. If you need further assistance, contact the MCI Customer Support Center at (800) 241-2947. About the 87a or the center wire in the relay socket we have no use on it just tape or you can cut. Service Bulletin #1930 explains the procedure on converting your older MCI coach over to 12-volt headlamps. Question: how can i connect my wring relay kit?
Sydney cole hookup, What is a 50 amp hookup, Best free hookup sites and apps, Hookup id scam,
As a result, I had turn/DRL on the bottom and top, but after awhile one side the lights would sometimes shut off. T your labeled wires with high-IN tap and twist it to the coil feed(line-in,stock wiring) from where your high relay should be then solder and.tape or use a shrink tube. Then the other end of the wire you needs the male spade terminal slice your wire about 1/2inch then crimp the terminal with your crimping tool. I bought an HID kit with H11 connectors to plug straight to the connector on the low beams, but have 9006 connector adapters so that it fits my OEM wires. Headlight Wiring - 12-Volt Lights on a 24-Volt System. The 2006 lights have 4 plugs from what I remember, low, high, city lights, and turn signal.
Find me a hookup, Hookup in Pasadena, Gay hookup columbus, Nh hookup sites,